 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
LP gas supply
I recently replaced the LPG meter on my home. After completing the installation, the gas cooktop and clothes dryer both work fine, but the water heater and space heater pilot lights won't light (no gas?). Do these appliances contain some sort of low-pressure shut-off that needs to be reset before restoring gas flow?
Help! (These cold showers are difficult to get used to) Djh |
||||
|
||||
|
Air may have entered the line while you were replacing the meter. Is the water heater and space heater father away from the meter than the stove? Purge the line by removing the drip leg cap or briefly opening the line close to the appliance. You can purge the air by just holding the pilot light button down but it will take some time..
|
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
I have just started remodeling my kitchen and am looking to move my kitchen sink further down the wall. The kitchen is completely gutted at this point. The supply lines in my house are all brass. I'm looking to stem off the brass lines using copper tubing. Is it possible to cut the brass supply...
I wanted to know difference between 3 phase and 1 phase conceptually
What size meter trails should I use for a 200 amp supply 2 my this board ?
I am roughing in a water supply for a urinal and it calls for a 3/4 inch I.P.S. Not to sound stupid but what does the I.P.S. stand for? Is it just a 3/4 inch copper pipe? Thanks
Tom, how are you? Hope you had a great holiday. A couple of quick questions. Is 1/2 inch supply lines for my wirlpool tub OK, or do I need to run 3/4 inch lines. Second , is my stub out for my new toilet to be in a certain location or can it be placed anywhere close? Is there a standard location...
View more questions Search
|
