Ask Experts Questions for FREE Help !
Ask
    jimdaisey's Avatar
    jimdaisey Posts: 2, Reputation: 0
    New Member
    		  
    #1

    Jun 18, 2008, 08:08 AM
    Install murray solenoid
    What wiring needed on replacement solenoid for murray rider mower
    jimdaisey's Avatar
    jimdaisey Posts: 2, Reputation: 0
    New Member
    		  
    #2

    Jun 18, 2008, 08:10 AM
    Hot and ground from battery to solenoid leads
    MOWERMAN2468's Avatar
    MOWERMAN2468 Posts: 3,214, Reputation: 243
    Ultra Member
    		  
    #3

    Jun 18, 2008, 05:13 PM
    You will have a ground to the body of the unit, a hot wire to the switch, a hot cable from the battery and a hot cable to the starter.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Solenoid wiring for a Murray Riding Mower [ 8 Answers ]

Can anyone tell me how to wire a 12HP 38" Cut Murray Riding Mower from the switch to the solenoid to the battery. I have one wire that attaches with a clip to a post on the solenoid and a yellow wire that goes to the switch or the seat cutoff and a large red wire with a smaller red wire attached...

Solenoid replacement Murray 12.5 lawn tractor [ 1 Answers ]

Any help on replacing a solenoid on Murray 12.5 hp lawn tractor Thanks

Wiring solenoid for a murray rider [ 1 Answers ]

Replaced solenoid for my murray rider and forgot how the wiring goes.. 3 post dual mount...

Murray rider starts but from solenoid only [ 1 Answers ]

Won't start from key ingition I replaced starter and solenoid the only way its cranking is from jump starting by solenoid

How to rehook solenoid on Murray Lawnmower [ 1 Answers ]

I have a Murray Riding Lawn Mower. It was given to me and it won't start. They replaced solenoid and wanted to make sure how it is supposed to be hooked up. The model # is 52100x92a

View more questions Search