 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Briggs 14.5 will not start
I replaced the aluminum gear that the starter turns to start the engine and after I put it back together the mower will not start. The engine is getting gas because I pulled the spark plug and checked. Is there any electrical connection that may have come loose or is there any thing under the fly wheel that did not go back in place.
|
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
I have replaced the piston and rings in this engine and still have a no start condition. I've run the gammet on this one and have come down to valve timing. When aligning the timing marks, the engine isn't at TDC. How do I find out if the cam isn't 180 degrees out? I can assemble it both ways but...
I have a Briggs 14.5hp riding lawn mower that when you try to start the flywheel won't turn or will make a slow turn and pause then another slow turn and stop. I cleaned the ground cables, replaced the battery, carb, and spark plug. Trying to jump across the solenoid doesn't work either so its not...
The engine ran fine last season and haven't tried to start it since but had to replace flywheel and starter gear to start this year. After replacing the gears and installing a new spark plug and charging the battery the engine spins freely and backfires but doesn't start. I don't know much about...
I have a 16.5 ovh Briggs in an MTD. The mower started and ran fine the last few mowings. However, now it will not fire. The starter will turn the motor for a few seconds and then it will "bog" down. I can turn the motor by hand past the "hard" part of the engine cycle and the starter will turn the...
View more questions Search
|
