Ask Experts Questions for FREE Help !
Ask
    bulldawg6's Avatar
    bulldawg6 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    May 31, 2008, 11:30 AM
    Won't start
    I have a Craftsman 4200 Lawn tractor that I can't get started. I have fresh gas in it, have checked the spark plugs and have spark, fuel lines are all flowing, pump works. I think that the problem is in the carb but can't figure out how to get to it to see if it's plugged. Any suggestions? Anything else I should be looking for? I have poured gas into the carb and can get it to run for about 10 seconds. That's it. Any help would be greatly appreciated.

    Thanks.
    MOWERMAN2468's Avatar
    MOWERMAN2468 Posts: 3,214, Reputation: 243
    Ultra Member
    		  
    #2

    May 31, 2008, 07:27 PM
    Remove the carb bowl and see if you have any trash or water in the carb.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Where do I start looking for grants to start up construction business in Mn. [ 3 Answers ]

Hello,I am John and I would appreciate any help I could get on finding some grants or low interest loans for starting a concrete contracting business.I have searched some sites but most want money for a kit.My credit is not very good and I am just trying to start a small construction business.I am...

Can't start my Poulan chainsaw. Start rope too hard to pull. [ 1 Answers ]

Can't start my chainsaw because the start rope is too hard to pull out. Pulling the rope causes a jerky action.

Tractor won't start with key - but I can jump starter to start [ 2 Answers ]

I bought a used Ford 1210 compact tractor and it will not start with the key. I replaced the switch and still no luck. Tested the safety switch & wire that goes to the starter and both are in good order (verified with ohm meter). When I try to start with the key, the lights dim some so I can see...

91 honda crx no start or rough start, puzzled HELP! [ 5 Answers ]

Ok, I'm running a SOHC ZC motor. I have good compressions across all pistons at 135psi and holding a piece. I have checked the timing and it is correct. I have checked the fuel pressure and it is OK. I haven't been able to figure out how to lean the fuel out though, but anyway, it starts up and...

View more questions Search