Ask Experts Questions for FREE Help !
Ask
    stoneljen's Avatar
    stoneljen Posts: 2, Reputation: 1
    New Member
    		  
    #1

    May 10, 2008, 03:37 PM
    new thermostat
    I have a braeburn 1200 the set up is
    red = r
    orange = o
    blue = c
    yellow = y
    green = g
    white = w2 and is jumped to e

    the new thermostat is a honeywell rth7000 it has
    c
    g
    y
    o/b
    rc
    r
    aux
    e
    l
    The instructions do not help
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    May 10, 2008, 06:13 PM
    See page 10. The instructions are very clear. The instructions are exactly the way I would hook it up if I was there. Do letter for letter and READ the set up instructions.

    http://customer.honeywell.com/techli.../69-2104ES.pdf
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Wiring codes from old Carrier thermostat to new Hunter thermostat [ 1 Answers ]

WIRING CODE HELP FOR THERMOSTAT I am in an office and have an old Carrier programmable thermostat which no longer works. I purchased a Hunter 44660 thermostat to replace. My problem is that the wiring codes on the previous thermostat do not match up the codes on the new thermostat. Codes and...

Changing over from White Rodgers Thermostat to Honeywell thermostat [ 3 Answers ]

I have a White Rodgers 2 stage heat/1 cool model 1F58-58 heat pump thermostat that I want to change over to a Honeywell programmable thermostat model RTH7400. I need help in trying to figure out the wiring part of this whole thing. Can someone out there please help. I would certainly appreciate...

System does not react to thermostat, thermostat set to off, AC still runs. [ 3 Answers ]

We had a new AC system put in this summer. I turned it off as the weather moderated, but even though the thermostat is set to off, the AC runs. It also looks like the heat does not run. It was chilly last night and I turned the thermostat to heat on and set the temperature appopriately, but no...

Thermostat turns on furnace and then thermostat shuts back to HOLD [ 7 Answers ]

I believe that when we re-run the program with the correct date and time, if the temp has to go up, the furnace runs until it gets the appropriate temp, then it turns off and when it does that, the thermostat also turns off going to the HOLD state.:confused:

View more questions Search