Ask Experts Questions for FREE Help !
Ask
    pican00's Avatar
    pican00 Posts: 17, Reputation: 1
    New Member
     
    #1

    May 5, 2008, 03:46 AM
    Drywall in bathroom?
    I have gutted my entire bathroom. I am planning on installing regular drywall except near the tub/shower where I will use backer board. Is this OK? I thought since the walls behind the vanity and toilet will not have much if any direct contact with water it shouldn't be a problem. I am also planning on tiling over the drywall. Also, I am installing insulation in the walls except on the tub wall since it is facing into the house. Do I need to use a moister barrier between the insulation and the drywall?
    cleanfun's Avatar
    cleanfun Posts: 26, Reputation: 10
    New Member
     
    #2

    May 5, 2008, 04:19 AM
    They make waterproof sheetrock for high moisture applications.

    You're probably going to want to use cement board. Especially for tiled walls and ceiling where you need some extra strength.

    They also make some stuff called greenboard. Greenboard is moisture repellent with different paper and bonding agent but isn't really as strong. I'd stick to the cement board.

    You'll also want to caulk every nook & cranny and add a sealing/primer coat or two before you tile & paint.

    When painting/priming, check out this stuff called Kilz. Masterchem Industries, Inc.

    Have fun & good luck.
    hkstroud's Avatar
    hkstroud Posts: 11,929, Reputation: 899
    Home Improvement & Construction Expert
     
    #3

    May 5, 2008, 05:29 AM
    Insulation comes either faced or unfaced. You want the faced insulation, that is your moisture barrier. The moisture barrier always goes to the warm side. Adding an additional moisture barrier would not be recommended.

    Using regular drywall in the non-shower ares is fine but personally I like to use green board through out the bathroom. The extra resistance to moisture in an high humidity area is well worth the extra cost in my opinion.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Drywall [ 6 Answers ]

My home is about 25 years old. Recently I've noticed that the drywall screws seem to be coming out. There's small bumps in the drywall where the screws are. In one room, the opposite is happening. Instead of bumps, I have small depressions around the screws. Is this situation serious and what...

Drywall on ceilings [ 7 Answers ]

We are building our own home to earn equity program. My husband hung our drywall using 1/2 inch sheets on the ceilings with 24" in between joists. We have been told by our drywall finisher that the ceiling will sag because we were supposed to use 5/8. Is there anything we can do now to correct...

Another one about drywall. [ 2 Answers ]

So I paid someone to finish my drywall. He "completed" the job while I was at work, so I didn't get a chance to look at it. When I got home I noticed that he had only sanded with 100 grit paper, and there are sanding lines everywhere! Is this standard practice? I have always used 220 grit, and...

Drywall texture [ 1 Answers ]

When removing wallpaper, it pulled off some of the drywall paper. Can texture be put over this, or do I have to replace the drywall?

Drywall to drywall [ 2 Answers ]

I need to resurface a wall that has a layer of 1/2" drywall with another layer of 1/2" drywall. I intend to use laminating adhesive and type g gypsum screws. Do I need to be concerned about getting these screws into the studs or just screw drywall to drywall?


View more questions Search