Ask Experts Questions for FREE Help !
Ask
    LonH's Avatar
    LonH Posts: 3, Reputation: 1
    New Member
     
    #1

    Apr 30, 2008, 12:03 PM
    Connecting washer wastewater in basement
    Hi,

    In my basement, the drain pipe to the septic system looks like the attached picture (I apologize for the poor picture quality here).

    We had the vertical pipe capped prior to moving in at the recommendation of the home inspector. However, the pipe is/was was the drain pipe for the washing machine. The previous owner simply fed the outlet of his washing machine into the open end of this pipe.

    For history, the home is 30 years old; we are the second owners. The washing machine has always been in the basement in this configuration.

    (1) Is it safe to uncap this drain pipe and connect a small sump pump+check valve to it in a sealed fashion (where it's sealed to past the check valve)?

    For example, am I likely to experience any dramatic changes in backpressure with a closed system that I wasn't likely to experience with the previous open system?

    (2) Is it to ICC 2006 plumbing code to do (1)?

    Thank you for your time in advance.
    Attached Images
     
    LonH's Avatar
    LonH Posts: 3, Reputation: 1
    New Member
     
    #2

    Apr 30, 2008, 12:14 PM
    Quote Originally Posted by LonH
    (1) Is it safe to uncap this drain pipe and connect a small sump pump+check valve to it in a sealed fashion (where it's sealed to past the check valve)?
    Small detail - the sump pump would only be used to expel washing machine wastewater and dehumidifier water from a basin; e.g. a Drainosaur.
    LonH's Avatar
    LonH Posts: 3, Reputation: 1
    New Member
     
    #3

    May 5, 2008, 11:45 AM
    After talking with the plumber who capped the pipe, he noted that capping it in the first place was a bit of a silly thing to do, and that he'd feel like a crook for coming out to saw off the end of the pipe. For now, we're just going to saw off the end where the cap is.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Connecting kitchen sink in basement. [ 3 Answers ]

Hi, I'm completing my basement and adding a small kitchen. My intention is to run the drain to a waste stack several feet away and use a cheater vent under the sink. The waste stack is 3" and has a toilet from the main floor connecting to the top of the stack. About 1 foot below that is a 1-1/2"...

Connecting a wet bar sink to a basement rough-in [ 1 Answers ]

I am finishing a basement bathroom for which I have a rough-in, and will have to break into the concrete to move the tub drain a few inches because it was misplaced originally (Thanks for confirming that on my earlier post, speedball1). Since I will have to break into the concrete anyway, I was...

Connecting Ventless Washer/Dryer [ 3 Answers ]

I've just spent nearly $1,500 on purchase and delivery for a Supra SW5L30D that connects to the kitchen sink faucet with a tap adaptor and unicouple. The ads and instructions do not warn that, if sink also has a spray attachment hose, to disconnect sprayer hose and plug hole. I read today on a...

Connecting a washer in the basement [ 1 Answers ]

I just purchased a house few months ago and there are no hot and cold water supply lines for a washer what's the best way? Tapping them directly from the hot water heater as well as how would I implement a stand pipe in the set-up. My main sewer pipe runs along the wall of the basemnt about 5 foot...

Connecting Washer To Tub [ 2 Answers ]

Hello. My spouse and I are moving into a new rental property which has a "utility room" for the washer and dryer. There is a vent for the dryer, but according to the landlord the washing machine has to be connected to the tub faucet. Apparently, former tenants have done this. I do not currently...


View more questions Search