Ask Experts Questions for FREE Help !
Ask
    firestalker's Avatar
    firestalker Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Aug 21, 2007, 05:53 PM
    Frigidaire Dryer Bearing or Roller?
    I have a Frigidaire dryer about 7 YO it has started to allow clothes to get stuck between the drum and the bottom of the outer opening. They get stuck which ruins them leaving a burn mark on the clothes. If I reach inside the drum I can push the front up about 1 inch which closed the gap where the clothes get pinched.

    My question is do you think the rear bearing or the rollers are worn out allowing the drum to have slop in it or might it be another problem.

    Thanks Gary
    jetmen's Avatar
    jetmen Posts: 2, Reputation: 1
    New Member
    		  
    #2

    Apr 21, 2008, 08:33 PM
    Gary,
    I think you need to read this:
    Partselect.com - Frigidaire Dryer Parts And All Brands of Appliance Parts
    And consider replacing the Drum Glide - Top but do not stop there you may also need to replace the Seal-Basket Lower:
    Partselect.com - Frigidaire Dryer Parts And All Brands of Appliance Parts
    Good Luck, Joe
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Frigidaire dryer [ 2 Answers ]

How do I replace the thermal limiter. I have taken the screws out of the clips, but can't get to the part. The top won't come lose.

Squeaky Dryer Roller [ 1 Answers ]

I've got a Maytag Electric Dryer with a squeaky dryer roller. The rollers do not look worn on (I'm assuming that the wheel part is supposed to be smooth and didn't at some point have treads that have worn away). I'm not sure whether the sqeak comes from the roller wheel against the dryer drum or...

Rear bearing on General Electric clothes dryer [ 2 Answers ]

Can anyone tell me how to replace the rear bearing on dryer model DDE6500GALAD? I can put a drop of oil on it from the rear of the dryer and it stops squeaking for a few loads but then starts again. I can't find any documentation for it on the GE site. Thanks

View more questions Search