I am currently trying to remove a wet bar from my basement.it has a sink and I have disconnected the water running into it but I have no idea how to remove the abs piping that runs into it I also have no clue how to cover up this drain once everything is removed any tips would be helpful and appreciated

Quote:

---

Originally Posted by thesunsseed

i am currently trying to remove a wet bar from my basement.it has a sink and i have disconnected the water running into it but i have no idea how to remove the abs piping that runs into it i also have no clue how to cover up this drain once everything is removed any tips would be helpful and appreciated

---

You saw off the ABS pipe as close to the wall as possible. Use a plastic test cap to seal the open end. If you wish to hide the pipe entirely then after you cut the pipe off next to the wall take a set of inside cutters and make your cut just inside the dry wall. You may use a test or a hardcap to seal it. You can then patch the hole. Good luck, Tom

Thank you speedball that was speedy only one thing the pipes are being run from the floor up through the wet bar is it still safe to saw it because that was my initial thought then I can remove wet bar and try covering the hole hole with something and truly thank you so much for your help

Quote:

---

Originally Posted by thesunsseed

thank you speedball that was speedy only one thing the pipes are being run from the floor up thru the wet bar is it still safe to saw it because that was my inital thought then i can remove wet bar and try covering the hole hole with something and truly thank you so much for your help

---

Floor or wall, all the same treatment. Good luck, Tom