Txgreasemonkey

Can you walk me through the K-test, there are many circuits I can test for low voltage?
Do you have an image that can help me test the right one?

Thank you

The K-Test: Remove the MAP Sensor connector and turn the ignition switch to ON (not start). Using a multi-meter, check for 5 volts going between the MAP Sensor connector's reference wire (+) and ground. As you look at the connector, this is the socket on the right. Really press the black test lead into a cleaned main ECM ground on the thermostat housing. If the voltage is low, it's probably indicating ECM failure. Most failed ECMs will record a fraction of a volt.