I have a Maytag stacked washer dryer. Model #LSE7804ACE.

Should the heating element come on and go off during the drying cycle. The dryer itself never shuts off. The fan is blowing and the duct is new. I can watch the element come on and go off.

I have recently noticed it takes longer to dry clothes so I cleaned the lint out from inside the access panel and replaced the vent. This is when I thought I would check to see if something was wrong with the element and noticed that looked fine other than a little droopy but then it went off and a few minutes later it came back on?

Any help appreciated!

Yes. There is a thermostat that prevents the dryer from getting too hot, baking your clothes. Not sure if it cuts it off entirely - may just regulate the current. Your checking it outside it's natural design very well could have an effect as you noted.
Since you have cleaned it up really good, it very well may be more quick.

Yes, the element shuts completely off when it has reached the regulating thermostat temp. You didn't say how you observed the element going on and off. If you saw it by having the dryer door open then it will short-cycle because insufficient airflow over the element will trip the hi-limit thermostat, which is a safety feature.

Quote:

---

Originally Posted by RalphS

Yes, the element shuts completely off when it has reached the regulating thermostat temp. You didn't say how you observed the element going on and off. If you saw it by having the dryer door open then it will short-cycle because insufficient airflow over the element will trip the hi-limit thermostat, which is a safety feature.

---

Thanks guys.

Ralph,

It is a stacked unit and there is a panel with two screws that I could loosen one side and peek in and see the element glowing red and then go off.

This thing does not have a fan blowing over the element though, so I am unsure about insufficient airflow though.

I have attached some pics. Do you think the element appears to be a little droopy?

http://i89.photobucket.com/albums/k2...g/P1040318.jpg
http://i89.photobucket.com/albums/k2...g/P1040319.jpg
http://i89.photobucket.com/albums/k2...g/P1040315.jpg

The element is OK, they droop, as long as it's not touching the metal can, it's OK. The fan is located on the left, under the housing cover where you see the thermostat and thermal fuse. When it's running the fan sucks air through the drum and through the can which houses the element.
If you have heat and proper airflow, it should dry the clothes within an hour depending on the material being dried.
If the washer doesn't extract the water properly during the spin cycle, it's will take a lot longer for the clothes to dry. The way to test it is after the washer has completed it's cycle, take a towel ar wash cloth that has been washed, wring it as hard as you can and no water should be dripping out.

Quote:

---

Originally Posted by RalphS

The element is OK, they droop, as long as it's not touching the metal can, it's ok. The fan is located on the left, under the housing cover where you see the thermostat and thermal fuse. When it's running the fan sucks air through the drum and through the can which houses the element.
If you have heat and proper airflow, it should dry the clothes within an hour depending on the material being dried.
If the washer doesn't extract the water properly during the spin cycle, it's will take a lot longer for the clothes to dry. The way to test it is after the washer has completed it's cycle, take a towel ar wash cloth that has been washed, wring it as hard as you can and no water should be dripping out.

---

Thanks Ralph I will try that with a wash cloth. I had not really thought about that the clothes may not be spun dry enough.https://www.askmehelpdesk.com/images/icons/icon14.gif