Good evening everybody. I have a few items to install for an Audio System upgrade; but don't know how to go about it. The Items that will be involved are -1 Distribution Block -2 Amps. -1 Capacitor. -1 Equalizer/Crossover -6 Speakers in Total (2 tweeters, 2 Front Door 6.5's, and 2 6x9's) -1 Subwoofer

I'm trying to connect 2 amps; 1 for the Subwoofer and the Second for Speakers. My Aftermarket Head Unit has 3 pairs of RCA plug-ins.
1) Subwoofer 2) Front 3) Rear.

How Would I connect the 6 speakers (which I'm going to rewire) to the 1st amp? Do I wire the Speakers to the Amp or Straight to the Head unit itself? Also, how would I connect the amp to the Head unit if it only has the 3 RCA plug-ins as stated above?

Any advice or suggestions are Welcomed. Thanks in advance.

Can you give models of the equipment, You may need to do a series/parallel with the speakers to maintain the Impedance.
Need Impedance of Speakers and Amps Impedance.

I found this interesting blog site that may help you synch your amps/speakers for good effect.

How to sync two different amps - Amplifiers / Head Units / Processors / Electrical - SSA Car Audio Forum

And this gem,

https://www.rigolna.com/products/dig...content=DS2000

Or go pro

https://www.sweetwater.com/store/det...7_t-1514569965

Thanks for commenting.. I have the Big 3 upgrade. As for equipment; it goes as followed:
Head Unit: Kenwood. KDC-BT555U
Equalizer/Crossover: Lanzar Vibe XE3
Distributor Block: Scosche.
Capacitor: Tsunami 2 Farad 20VDC

As for Amps; I have a variety which Consist of...
Dual XPR52 (2 Channel Amp.)
Kicker DX-A250.1 (2 Channel Amp)
Mmats Pro Audio E600.4 (4 Channel High Power Mosfet Amp)
Boss CH2502 (2 Channel Mosfet Power Amp)

Speakers: 2 Boss Tweeters, 2 6.5's Orion HCCA with Red Housing Door Speakers, 2 6×9's Almani in the Rear Deck.
Subwoofer: MTX Thunder US-XT10-04

Thanks again for everyone taking part in my assembly!