Kenmore dishwasher blowing thermal fuse
I have a Kenmore dishwasher, model #665.17779990. Over a year ago the lock light would come on and I had to reset the dishwasher and cleaned terminals at control board. I had to do this several times in the next couples months. At one point during this it blew the thermal fuse. I replaced the fuse and the wires that came with it with OEM parts. It worked for several months, finally I had to replace the control board. I used the remanufactured board. I worked fine for about 3½ months, then it blew the thermal fuse again. I replaced the fuse but did not change the wires a second time. It lasted about a week and has blown the fuse again. These last two times that it blew the fuse I believe it was during the rinse cycle as the soap dispenser was open and the detergent gone. The dishes look clean but there is still water in the bottom below the level of the heating element. Any suggestions would be greatly appreciated.
