I need to bend a 10' stick of 1/2" rigid into a square, with the two ends meeting on one side of the square. I'm using a 3/4" emt bender. Where do I make my bends? Thanks. Chris.
|
I need to bend a 10' stick of 1/2" rigid into a square, with the two ends meeting on one side of the square. I'm using a 3/4" emt bender. Where do I make my bends? Thanks. Chris.
Not as simple as you be hoping. http://www.gridalternatives.org/asse...enderGuide.pdf
Read Kleins rule #2
Are you being EMT as the title states, or rigid as your post states?
| All times are GMT -7. The time now is 11:11 AM. |