Hi guys I am new to this forum. I have some problems with my bryant furnice. For some reason it is giving me a 13 code flame roullout switch. I have to manually reset the switch. It will run fine for a while but after that the switch has to be reset again. Now the furnice can run fine for a week without having to reset the switch or it can run for a few hours. It depends. What should I check on it. If you guys could give some advice and suggestions that will be great. Thank you so much

Make sure all the orifices are open in the burner tubes. Trane has thin slits that sometimes get clogged with rust. Brush and vac out the burners.

Quote:

---

Originally Posted by ma0641

Make sure all the orifices are open in the burner tubes. Trane has thin slits that sometimes get clogged with rust. Brush and vac out the burners.

---

I will look at them this evening. I took them aut last year and cleand them. But I will do it again

Thank you for the advice and I will post back to let you know if it worked

So I took out the burners. They were a bit dusty but clean. I cleaned them again and I cleand the flame sensor too. I will see I this was the problem

The problem is still there even after the burners have been cleaned. Any other suggestions. Thank you