Hi- the plumber installed a polished chrome shower head in my bathroom. Water leaks out of the fitting. He was isn't interested in coming back to take care of this. I want to take it off and re-tape and tighten myself but I don't know what tool/wrench to loosen and tighten the head without scratching the polished chrome. Is there a particular wrench that is used? It seems I need something with a rubber coating.

Thanks...

Does shower head have a couple of flat sides on it?

Yes- It is a Kohler Devonshire.

Use an adjustable wrench, won't scratch.

Thanks- I appreciate the answer. I don't want to mess up the shower head.

Hi CHL31

If your shower head has a couple flat sides like Hkstroud asked about then you should be able to use a crescent wrench (see image) to remove the shower head. If you don't have any flat surfaces on the shower head you can always purchase a strap wrench (rubber coated like you mentioned is common)...see image.

Good luck!

Mark

Thanks Mark- I do have that adjustable wrench.

I did use the adjustable wrench. Put new Teflon, and tightened. Still spit water, just a little less. Used a little more Teflon, tightened to the point where I don't want to break the nut. Still spits just a bit. Very frustrating. I left a message insisting the plumber come back. He tells me I may need to swap out the head and piece that go into the wall.

If they were new out of the box, I have never used the shower and he installed it and in theory tested the connection, how could this be? I don't want to be a pain, but I know he left the first time without testing.

It certainly doesn't sound like it was tested as the dripping would have been noticed when testing. Regardless at this point, it sounds like the shower head has a hairline crack and probably needs to be replaced.

If you purchased the kohler faucet, the shower head should be under warranty. A quick call over to kohler telling them that the shower head is cracked and you need a new one should be all that is needed to get a new head shipped out to you ASAP (do not tell them more than needed here). After you get the new head, the plumber can return to install it, or if he is going to charge you, I'm sure you can install it yourself quick enough at this point!

If the plumber purchased the faucet, remind him that the valve is under warranty and that the shower head should be provided to you at no cost...installation is between you and him and whether he wants you for a customer in the future, or not!

I will add some legal advice, who cares if the plumber does not want to come out. If he did not do the job properly, he has to come out and fix it.

Reminders of complaints on local service boards, and even suing him for a refund in small claims court. I hate poor service and will often work twice as hard to make a service person do it right

I don't think your legal advice will hold much water, Fr_Chuck.

Here, because the "customer" touched the shower head (removed and reinstalled the shower head), the plumber can argue that it is the customer that broke the shower head and not him/her. Had Luke left the shower head alone, he might have a case for the courts should the plumber not respond, but because it was touched Luke cannot honestly say that he didn't damage anything, for sure!

Never mind that this is only a shower head that is under warranty. I say you pick your fights in life, and this fight isn't worth a "plug nickel" in terms of energy, gas, time, etc. I'm a stand on your principles guy myself, but not over a warrantied shower head...just not worth the aggravation!

Mark

Maybe I will try to get the plumbing supply house to swap it. The problem is I bought the unit at the end of December. I didn't use the shower sooner because I was waiting for the glass door to be installed. It was a custom door and took some times to get.

Picture

The plumbing supply house should understand that as they deal with people on long projects all the time, and like I said, it is only a shower head, so I'd be surprised if they put up much of a fight!