I have a Hunter fan that I had to replace the speed control . It has 4 connections on the speed control: 1,2,3,and L. I connected the wires one at a time when I disconnected the previous speed control. I can only get the speed to work on high and low. Although it seems to work The quick connect seems loose..
Can I directly connect the wires from the speed control to the lines coming from the capacitor? Is here anything else I am forgetting to do?

Suggest that you check for voltage on each switch setting. Possible that the original problem may not have been switch.

Quote:

---

Originally Posted by hkstroud

Suggest that you check for voltage on each switch setting. Possible that the original problem may not have been switch.

---

... Don't have anything to do that with... other suggestions... could the loose quick connect be causing it.

Buy a meter, cheap ones available at just about anywhere only $15.

Quote:

---

.could the loose quick connect be causing it.

---

Possible, that's why you need meter.