One day everthings fine next day the engine turns over but won't start I checked all wires etc got spark no bad fuse next day went out the look at the car tried starting it and it fired right up turned it off and it started up again not sure what it could be.

I would focus on the distributor. Normally, replacing the Ignition Control Module (ICM) and coil solves problems like your's. Be sure to apply a thin, even coat of silicone heat transfer compound to the back of the new ICM.

If the problem happens only when the temperature goes up during the day, the main relay may need replacing due to cold solder joints.

Can someone tell me how to change the icm and coil on a 97 honda accord

Ignition Control Module (ICM or Igniter) and Coil Replacement

Bench testing ICMs and coils is virtually useless. It does not come close to simulating the extreme heat that often causes these components to fail. I recommend replacing these critical and problematic components every 120,000 miles or 10 years, whichever comes first.


1. Disconnect negative battery cable, recording any radio codes first.

2. Remove hex-head machine screws (3), securing distributor cap to housing, using an 8mm nut driver.

3. Move distributor cap and wires off to the side.

4. Remove machine screw securing rotor to shaft, using a precision #2 Phillips head screwdriver. A 1/4-inch drive magnetic bit holder (e.g. Wiha 52650) with a #2 Phillips head bit works really well. It may be necessary to "hit" the starter once or twice, in order to rotate rotor for access to mounting screw.

5. Remove rotor and leak cover.

6. Unfasten ICM wires, remove coil mounting screws (on distributors with a coil inside), and set coil aside. Trick: Removing the coil first, on distributors with a coil inside, improves access to the ICM.

7. Remove both screws securing heat sink to housing, using a precision #2 Phillips head screwdriver.

8. Remove heat sink from distributor and unfasten both screws mounting ICM to heat sink, using a precision #2 Phillips head screwdriver.

9. Clean connections with #240 abrasive cloth or steel wool.

10. Coat the back of the new ICM (or old ICM, if reusing) with a thin, even coat of silicone heat transfer compound. This special silicone grease increases heat transfer to the heat sink. Failure to apply silicone heat transfer compound will cause the ICM to quickly fail. Arctic Silver 5 is recommended by an AMHD member, which is available at Radio Shack.

If the ICM and the heat sink are simply placed together, the small air gaps (insulator) that naturally exist between them will inhibit heat transfer. By filling these gaps, the compound allows a direct path through which heat can travel. Failure to apply this grease is one reason why some Hondas suddenly die. Attention to detail makes a big difference with modern day electronics.

11. Mount ICM to heat sink and reinstall ICM, ICM terminal wires, coil, coil wires, leak cover, rotor, and distributor cap. Ensure female ICM connectors fit snugly--crimp with pliers, if necessary.

Note: Distributor cap contacts can oxidize or corrode, creating high secondary resistance, which can result in rotor and ICM failure, reduced mileage, CEL coming on, catalytic converter failure, or failed emissions test. The secondary ignition system will destroy the ICM and coil, if you do not properly maintain the ignition system. This means replacing the distributor cap, rotor, and spark plug wires every 60,000 miles.

Thanks everybody for the help