Im replacing 1960s taps with modern ones and have realised that the shank on the new taps is a lot shorter than the originals so the water pipes now don't connect up. I could put flexible hoses in (not sure how to do that) or I could find new taps with longer shanks, trouble is all modern taps seem to have 50mm shanks. Does anyone know where I can get taps with longer shanks (70mm)?

Hi Psjmartin

Check with the manufacturer of the faucet as some manufacturers sell extension shanks for exactly this case. Otherwise, talk to the guys at a local plumbing supply house and see what they can recommend... should be able to get you some extensions... ;)

Mark

Cheers :-)

Quote:

---

Originally Posted by massplumber2008

Hi Psjmartin

Check with the manufacturer of the faucet as some manufacturers sell extension shanks for exactly this case. Otherwise, talk to the guys at a local plumbing supply house and see what they can recommend...should be able to get you some extensions...;)

Mark

---

You can probably extend those with brass nipples and couplers.

Good addition to my answer, Handyman! Only issue here would be that the couplings will get in the way of tightening the faucet to the deck (couplings end up where threads are needed to tighten faucet to deck).

However, if Psjmartin took some 1" pipe/tubing or may even need 1.25" pipe/tubing and cut a 1" sleeve that slipped over the coupling he/she could then add washer and nut (after the sleeve) and tighten all down!

Certainly cheaper than the extension shanks!

Mark

Tighten the faucet to the deck first THEN add the extensions.

If he/she could do that then they wouldn't need the extension shanks (or couplings and nipples)!