I am trying to replace 2 rocker switches at my front door. How do I push the wires back into the new switch? Is there a special tool or something?

You strip back the insulation. Most switches have a strip gauge embossed on the switch. Then push the wire into the hole. This assumes solid, not stranded wire.
This type of connection is known to develop bad connections over time. Better to put wires under screw terminals.

Quote:

---

Originally Posted by hkstroud

You strip back the insulation. Most switches have a strip gauge embossed on the switch. Then push the wire into the hole. This assumes solid, not stranded wire.
This type of connection is known to develop bad connections over time. Better to put wires under screw terminals.

---

The old wires were not stripped, does that matter? This rs does nt have a hole. It has fins that cut into the insulation!

Show pic of new switch or give model number.

Quote:

---

Originally Posted by hkstroud

Show pic of new switch or give model number.

---

Pass and seymoreCAT NO.SCO-70

I can't answer your question, but I think you meant Pass and Seymour. not Seymore.

Just to help people who might answer your question.

Quote:

---

Originally Posted by kyle_in_rure

i can't answer your question, but i think you meant pass and seymour., not seymore.

Just to help people who might answer your question.

---

Thanks! Guess I need to spell check! Lol

It appears that that switch is designed for mobile homes and does not require installation be in a fire rated box. It appears that the switch is disassembled and the wiring connections are made inside. Apparently the wires are forced into the connection slots when the back is reinstalled. I'm only guessing, can only tell so much from pictures.

Quote:

---

Originally Posted by hkstroud

It appears that that switch is designed for mobile homes and does not require installation be in a fire rated box. It appears that the switch is disassembled and the wiring connections are made inside. Apparently the the wires are forced into the connection slots when the back is reinstalled. I'm only guessing, can only tell so much from pictures.

---

So, maybe the back is what pushes the wires snug? Tried using plyers but no luck with those! Guess I'll try old switch with some old wire to see if that will work. Thanks

They are like the connectors you use on trailers, the wires are forced through a slot and it cuts into the wire. I would get a regular old work box and a new Decora switch and eliminate the entire setup.

Thanks guys! Neighbor fixed it and next I will be replacing all switches!

Well, you could tell us what he did.