Ask Me Help Desk

Ask Me Help Desk (https://www.askmehelpdesk.com/forum.php)
-   Plumbing (https://www.askmehelpdesk.com/forumdisplay.php?f=259)
-   -   Capped plumbing still overflowing (https://www.askmehelpdesk.com/showthread.php?t=715336)

  • Nov 8, 2012, 09:51 PM
    Kathryn1980
    I am remodeling my basement bathroom. Shower & toilet removed, capped both. When I try to use my washer, also in basement, water comes out of the line where the hose is. Didn't have any water problem until we removed the toilet & shower. Why is water escaping wherever it can?

    Did you cap any vent lines?
  • Nov 9, 2012, 12:46 AM
    Kathryn1980
    Quote:

    Originally Posted by ma0641 View Post
    Did you cap any vent lines?

    No. The only vent line I am aware of is on the roof. We checked that for clogs but fpund none. We capped where the toilet, shower & sink was. We have not sealed the caps, they are sitting over the openings except where the toilet was is a towel stuffed in.
  • Nov 9, 2012, 06:29 AM
    massplumber2008
    Possible something got in the drain line when removing the fixtures and has now moved further into the drain line causing issue.

    Otherwise, a coincidence here and the washer drain line is simply clogged and needs to be snaked/cleared... ;)

    Also, as part of the remodel I hope you are planning on adding vents to the plumbing in the basement, right?

    Mark
  • Nov 9, 2012, 06:53 AM
    speedball1
    OK! You removed the plastic test caps from your drainage. Why would you do that leaving a direct open line between between your house and the city sewer allowing sewer gas to enter your house? Not too swift a move.
    Mark pretty much covered it. You might have lost a piece of plastic down the drain where it's now blocking your washer drain or .as Mark pointed out, it could simply be a coincidence. At any rate snake the washer drain line. Good luck, Tom
  • Nov 9, 2012, 02:10 PM
    Kathryn1980
    Ok. I Don't live in the city. We didn't remove anything but the shower, sink & toilet. So we cap those places. Now, when we put a cap over where the washer pipe is, just to see, it blows one of the other caps off & floods the basement. So whatever we cap off it finds another way to overflow. I have no plumbing issues upstairs in the main part of my home, no backups or overflows.
  • Nov 9, 2012, 02:38 PM
    massplumber2008
    Hi Kathyrn

    Like we said, you have a blockage in the drain pipe. You need to get someone in with a snake and clear the drain line.
  • Nov 9, 2012, 02:43 PM
    Kathryn1980
    Thank you all. I was just under the impression that maybe there was no clog since I don't have any backup/overflow problems in the main part of the house & the problem didn't happen until we removed the stuff.
  • Nov 9, 2012, 04:27 PM
    massplumber2008
    Problem appears to be isolated to the branch drain serving the downstairs bath and washing machine drain.

    Good luck!
  • Nov 10, 2012, 07:44 AM
    speedball1
    Quote:

    We didn't remove anything but the shower, sink & toilet. So we cap those places. Now, when we put a cap over where the washer pipe is, just to see, it blows one of the other caps off & floods the basement.
    If these are test or hard cape s we're talking about then they must be glued in place not simply jammed in place. Good luck Tom

  • All times are GMT -7. The time now is 04:29 PM.