This bib setup was already there when I purchased the house. Picture show it coming
Out of the wall. With two pipe clamps hold a rubber tubing in place. Then there is a long galvanized pipe that has a elbow up to the hose bib for the garden hose. Look terrible. See picture. I need to shorten up the connection. Maybe
Just a short pipe with some threading on it maybe 6" straight out of the wall.
I would like a normal hose bib,like the picture

What is your suggestion.

I'll leave the actual plumbing to the plumbing experts but the 3rd picture showing what you call a normal hose bib does not appear to be a frost-free valve. If you are in an area that experiences temps below freezing temps, you should look into installing a frost-free valve.

I live in Florida. The pipe comes out of the wall turns and goes 6 ft then up to
The hose bib. It also is attached to the wall by a bracket Workmen are giggling

Maybe the previous owner couldn't bend over too well and needed to get the valve over and up so he could reach it--? Who knows? Just make sure that those guys aren't laughing all the way to the bank.

Ha Ha thanks

The pipe coming out of wall goes to an elbow. Is that a threaded connection?

Chuck

Yes but it terribly corroded. Also looks like someone paint it too.

Can u get to pipe on inside of house?

If u can, shut off water. Disconnect the short pcs of hose and unscrew pipe remaining.

On the inside use a PVC threaded adapter. Piece of PVC pipe to come through wall and a hose adapter on outside. Install hose bib. Turn on water.

Chuck

Thanks It can be done