Whenever we flush our toilet the whole pan fills up right to the rim but then goes down quickly but leaves tissue behind, were having to flush several times to get all the waste to go, we've tried soda crystals, drain unblocker, and even lifting the manhole cover outside and using rods, we've also tried a coil and a plunger, we really are out of ideas.

Hi Chapbeswick chu and welcome to The Plumbing Page at AskMeHelpDesk.com

I have one that most repair plumbers miss.. Look down at the bottom of the bowl. If there is a small hole, then that is a jet that starts the syphon action. If it's clogged the water will just swirl around and slowly go down leaving solids behind. Take your finger,(UGH! ) and run it around the inside of the opening. Over the years minerals build up and cut down on the syphon (flush) action. If it is rough or you feel build up, take a table knife and put a bend in it to get around the curve in the bowl and chip and scrap it clear. Next take a coathanger and clear out the holes around the rim. They start the swirling action. And last, check the water level in the tank. It should be 1/2" below the top of the over flow tube. And speaking of the overflow tube, Make sure the small 1/8" tube from the ballcock to the white overflow tube is connected so it discharges in it and that it's flowing when the ballcock fills. This is what raises the water level in the bowl. For a good solid flush they all have to work together. Hope this helps and thank you for rating my reply.. Tom