I have a single handle faucet in my bathroom. When I swing the handle to the cold side nothing come out. The hot side works fine. I tried to see if the cold line was clogged. After loosening the nut at the bottom of the line (near the cold water valve), I found it difficult to dislodge the line. The rubber washers were stuck. The plumbing is kind of old and I was afraid I might break something if I applied too much pressure.

Any suggestions/

Wallace

Hello Nunwall,

You started very well try to disconnect the line and you will know per sure wher the problem will be, when you disconnect the supply line if the water flow is good problem is with faucet if not then it will be the supply line or the angle valve, Thanks.

John