Trying to get this to run. Replaced many parts, tune up, battery, starter, fuel filter, valve cover gasket, spark plug wires. No codes now but just prior to stalling flashed 3 times and it stalled. Ran rough for a few days, would cut out on turns and had to gun it to keep running. What else could be wrong?

. Check all under hood and under dash fuses with a test light or multimeter.

. Crank the engine and try to force a code.

. Check for solid spark.

. Check for fuel. Does the fuel pump run, when the ignition switch is turned to ON?

. Check each cylinder's compression, after removing the spark plugs.

. Replace the Camshaft Position Sensor, if the problem persists.

Thank U...been trying to get codes but noting yet. Will repost if problem persists.