I have a 1989 Honda Accord DX (carborated not fuel injected) which was having a problem with stalling and sputtering. Was having an intermittant stalling and sputtering problem while driving the vehicle. If I drive at about 30 MPH and low RPMs the car drives and sputters. If I try to accelerate or the 30 MPH or higher RPMs it starts to stutter and sputter and stall. Also when I pushed in the Clutch the idle would jump to between 2000 and 3000 RPMs.

I have replaced the distributor, plugs, wires and the coil. I believe that the ignitor was replaced with the Distributor (Correct?) . I do not see a CEL on the dashboard where the owner's manual says it would be. After replacing the above mentioned items now the vehicle will not start. It appears that the starter is turning over but I don't think there is any fuel.

Is it possible the DX did not have a CEL .

See if reading sections A and B helps:

https://www.askmehelpdesk.com/cars-t...ics-46563.html

If the igniter is not new, have Autozone test it. They will do this for free. Make sure spark plugs are NGKs.

I turned the ignition switch to ON (not START), do not get a Check Engine Light (CEL). I don't see a CEL indicator as shown in the users manual. I looked in the under-dash fuse/relay box for the ACG (ALT) (S) fuse and was not able to locate it (all fuses were good both under-dash and under-hood, I found the EMC under the driver's seat. It has two connectors in it. Which one goes to the MAP Sensor Or better yet where is the MAP sensor located.