Hustler mower with 18 hp. Honda engine , no spark on ether plug. When it starts it will run and start all day, next day on start. The diode stop module was replaced, no spark, stop wires removed from coils no spark, resistance measurements at all points on each coil are the same. When the stop wire from the diode module is disconnected from the wiring harness that separates the engine from all safety switches no spark.
Help

Hi,
I need some numbers to proceed. I have access to Hustler manuals and Honda manuals, but need a place to start looking.
Peace,
Clarke

Quote:

---

Originally Posted by crigby

Hi,
I need some numbers to proceed. I have access to Hustler manuals and Honda manuals, but need a place to start looking.
Peace,
Clarke

---

From DUSTERSH
I have found there is no spark on ether plug when trying to start engine when the battery is 60,65% no lode. When a charger is hooked up in the start mode the engine will start every time. Once engine is started it will continue to start if it does not set to long. Got a new battery starts every time.

From DUSTERSH
I have found there is no spark on ether plug when trying to start engine when the battery is 60,65% no lode. When a charger is hooked up in the start mode the engine will start every time. Once engine is started it will continue to start if it does not set to long. Got a new battery starts every time.

Hi,
Most Honda engines of this type use a battery-energized coil for each cylinder. Check for good voltage at the coils.
Peace,
Clarke