Hello. As of today, I have a Crosley dryer. I am unsure of the specific model. My landlord bought it after I told him the dryer I had was not heating or shutting off on it's own. So he bought a Crosley today. I am now having the same issue with this new completely separate dryer, on the first use. I figure the odds of having two dryers with the same defect is pretty low, so I was wondering of you had any ideas about what could cause both of these dryers to not heat up or turn off. The timer knob does not turn at all from the beginning position. I thought I would ask here before contacting and bothering my ladlord again. I know that it could be something to do with a circuit breaker, but nothing is tripped in my breaker box should I look somewhere else? If it could be a wiring problem, how could I check that? Thank you.
Eden.

As to the problem of not heating, most likely it is dirty and lint deposits have built up, as it always does, in all the air ducts which will cause the main safety to blow. You need a multi-meter to fix a drier. A little vacuuming out does nothing. You will have to take it apart. You will have to clean the drier out thoroughly or it is all for nothing. Every air duct will have to be removed and scraped and washed out to remove baked on lint deposits which bakes on like a concrete lining. This will burn so the manufacturer has installed the safeties to keep from having a house fire. The safeties are oval-shaped with a round center part containing the safety with two plug-on terminals for the wires and when they burn open, from the dryer being dirty, nothing will work. Using an ohm meter you put a lead on each terminal of the safety, with one wire unplugged, and if it is good you will have a reading of about zero; if it is bad it will read infinity. Driers were the number one cause of fires at one time, hence now we have safety fuses. Look at: How to clean your clothes dryer. How to make it hot again. - YouTube to see how. Also: Mr. Appliance Tips: How to Clean Your Dryer - YouTube ; Cleaning a Dryer Vent and Lint Trap - YouTube
Electric Clothes Dryers
Whirlpool Dryer Model LE5800XSW3 Wiring Diagram | Dryer Repair | Fixitnow.com Samurai Appliance Repair Man
When you finish cleaning the drier it is best to also replace the belt, too, because you do not want to have to disassemble it all over again and if the belt is over two years old you should replace it.

Note that on most of the videos it does not show them washing out the parts, but this is important because it's the only way to really get the parts clean, just don't get motor wet or the capacitor if it has one. Vacuum out the motor to remove all dust. I would move the drier out to your garage to have plenty of space to work. You also want to check your vent and clean it, also. The vent should have a short run and be straight as possible. The job is really easier than it sounds. There is no shortcut that will work; it has to be cleaned well. Before you re-assemble it make sure to use white lithium grease (high-temp grease) and grease all bearings. Just vacuuming out the dryer a little does little good. As far as the dryer not turning off, you have a stuck contact somewhere. You may be able to unstick it by tapping the handle of a screwdriver against the timer which is where the contacts are located or you may need a new timer. You could find one at a used appliance store cheap. Here are some manuals that may help: http://dl.dropbox.com/u/8010163/GE%2...%20Manuals.zip DrTom4444