I have installed a GE Z-wave on/off relay switch.

There are four connections, the black load line, black hot line, white neutral line and green ground line.

The switch is a touch pad type, not a rocker.

When the pad is touched the lights go on and quickly go off. Almost as if the switch itself is acting as a breaker.

I have thoroughly checked all of the connections for tightness, including the ground.

The switch will continually activate the lights for a brief moment similar to a camera taking a flash picture.

Thank you for considering a solution for this problem.

Tim from Temecula

Zw4001
Signal frequency 908.42 MHz
Maxium loads 600W

Is the link I provide the manual for your exact unit? If not, what is the exact model number you have?

http://www.jascoproducts.com/support...Manual-Eng.pdf

What is the benefit of using this type of switch? Why are you using this switch?

Are you using it as a single pole or 3 way?

As mentioned, single pole or 3 way?
I haven't used these, but check if there is something to change from Momentary to Maintained?