This shower has a master bath on the same wall with this shower, it look as if the bathtub drain join the shower drain, can not tell how to replace a shower drain pipe in a concrete floor, it is about 3' down to the tape, someone poured something that has harden and can not be snaked out.


NOTE: Answers to this question will be posted as "AskMeHelpDesk" on our Facebook page - NOT your username, unless you wish to answer with your own FB profile, in which case, go to the AMHD Facebook Page and answer using commenting.

I don't "Facebook" so you may post my user name if you wish. This is a typical bathroom drainage set up, (see image) Ordinarily the solution would be to jack hammer up the slab and replace the drain line. But I recommend this only after I've tried everything else. Since you don't know what's down there or how much there is why not rent a Ridged K-30 (3/8ths" cable and put a cutter tip, (see image) on it and attempt to grind your way through the blockage? It's worth a trey and a lot cheaper then tearing up the slab, Good luck, Tom



Cliff, You may present this any way you choose. If you have more, bring them on and we'll answer as best we can. Tom