I am not receiving water to one toilet. All bowls, sinks and showers on the same line are receiving both hot and cold water. Its only one toilet that failed to fill. When checking the line, it is not receiving water at the valve.

Quote:

---

Originally Posted by krmorton

I am not receiving water to one toilet. All bowls, sinks and showers on the same line are receiving both hot and cold water. Its only one toilet that failed to fill. When checking the line, it is not receiving water at the valve.

---

At what valve? The ballcock or the angle stop? What type ballcock do you have? Float ball on a rod or can on a wire? Cheers, Tom

I am not receiving any water to the supply line. Its as if the water has been turned off.

Turn the water off at the house stop and pull the angle stop. Hold a pan over the stub out and have someone turn the water on for a few seconds to flush out the branch line. Is there a strong stream now? Check the seat in the angle stop and clear it if necessary. Reassemble and test. Good luck, Tom