Old belt broke, so no reference. I found the general routing on the web no problem, but it lists no procedures to follow as far as what to remove under the mower etc. I had it routed pretty much per the diagram, but the belt was rubbing on a bolt head. Looks like I need to loosen the steering nut and lower the plate down to route it correctly, just wanted to ask before I do too much work :)
Deck is removed already, as is the battery etc.

[QUOTE=;][/QUOTEHi, try this one .

remove the covers over the pulleys on each side . Jack up front of mower .
Release front deck hanger , then work the belt in put belt on engine pulley last.

Luck

Thanks guys, I went out there this morning and lowered the plate that goes above the deck. Got it figured out where the belt is not rubbing on anything that doesn't spin :)
Wife drove it around, so all is good.
Many thanks for the replies.

Martin