I tried to dry my clothes this morning and after I cleaned it and twisted the knob I could hear the timer clicking but when I proceeded to hit the start button it wouldn't start. Nothing. Not even like it was trying to start. I flipped the breakers but it did nothing. I really can't afford a new dryer. What could this be and what could I do? HELP PLEASE

For starters, take a look at this post. Depending on how handy you are, this could be a relatively simple (cheap) fix.

Best of luck,
WallyH

You will have to take it apart and test the thermal fuse near the heating element. Most likely it is blown and will have to be replaced, but you will have to clean the drier out thoroughly. Every air duct will have to be removed and scraped and washed out to remove baked on lint deposits which is like concrete lining. This will burn so the manufacturer has installed the safeties to keep from having a house fire. Driers were the number one cause of fires at one time. Look at: http://www.youtube.com/watch?v=MMP7BW1lLs4 to see how. Also: http://www.youtube.com/watch?v=iBiRw-KElC4 ; http://www.youtube.com/watch?v=yFTZGgVisCI
When you finish cleaning the drier and install a new safety it is best to also replace the belt, too, because you do not want to have to disassemble it again and if the belt is over two years old you should replace it. The safeties are oval-shaped with a round center part containing the safety with two plug-on terminals for the wires.
Using an ohm meter you put a lead on each terminal with wires unplugged and if it's good you will have a reading of about zero; if it's bad it will read infinity.
Note that on most of the videos it does not show them washing out the parts, but this is important because it's the only way to really get the parts clean, just don't get motor wet or the capacitor if it has one. Vacuum out motor. I would move the drier out to your garage to have plenty of space to work. You also want to check your vent and clean it, also. The job is really easier than it sounds. There is no shortcut that will work; it has to be cleaned well. DrTom4444

My ge dryer will not start the light comes on but nothing else happens