Car was in shop having a axel put in and they did somting and they said smoke was rolling outt the dash now the car keeps poping the starter signal fuse what does this starter signal fuse work or run I'm just going to run a new wire as long as I can find ourt were it goes

Check the ignition switch for wear, pitting, or melting:

https://www.askmehelpdesk.com/cars-t...tml#post224652

Switch seams good I think they melted a wire and its causing a dead short,but what ever it was its not letin me get power to my main relay so no spark no fuel think I could by pass it with a new wire just need to know were it goes and what it runs.
From what I understand the starter signal fuse runs power to both the ecm and the main relay I'm getting power to the ecm because the lights coming on properly, but not the other way need like a wire diagram from the fuse box or somting

It goes to Terminal 6 on the main relay. Try substituting another main relay, if you have one. Otherwise, I suspect a problem with the ECM.

You don't think a melted wire is the cause the car was smoking but I have both a main and ecms

Yea, it's possible but I assume you check that sort of stuff out early on, if you suspect wiring may be a problem.

So the starter signal fuse wire runs to terminal 6 then stops? What about before the fuse? Were does it come from? And were can I get a diagram of it?

That's why I initially suggested the ignition switch may be bad.

OK so from switch to fuse box to main relay,

Yes.