I have an older GE washer (about 5-7 years old) that has started making a loud, dry metallic grinding sound when running.

I had to replace the clutch about 4 years ago and recently the clip that holds it in place came loose and I had to snap it back in place. The washer worked fine for a few weeks, then started running extremely loudly. I've made sure it is level and ran the spin cycle when empty and it still made the noise, so I don't think it's a balance issue.

The clutch has somehow gotten rusty and could be a part of the problem, there is also rust on the motor. I have no idea how either could be rusty, since it's always been inside and I've never noticed any leaks from it. There is no evidence of oil anywhere, but I did notice a good amount of metal shavings, likely from when the clutch came loose.

I can replace the clutch again with no problem, but I wonder if I need to replace the motor, or if it could be something else.

Thanks

How is the condition of motor shaft. The clutch is keyed to motor shaft.If is worn so much that the clutch will not staying on securely then it will come loose again.They have a new replacement motor now that is clutchless.They are a lot better motor.single and two speed motor.

The motor shaft looks like there has been some stress right at the point where the two posts are that line it up to lock the clutch into place.

What's the price on those clutchless motors and where can I find them?

Thanks

Quote:

---

Originally Posted by kjak

I have an older GE washer (about 5-7 years old) that has started making a loud, dry metallic grinding sound when running.

I had to replace the clutch about 4 years ago and recently the clip that holds it in place came loose and I had to snap it back in place. The washer worked fine for a few weeks, then started running extremely loudly. I've made sure it is level and ran the spin cycle when empty and it still made the noise, so I don't think its a balance issue.

The clutch has somehow gotten rusty and could be a part of the problem, there is also rust on the motor. I have no idea how either could be rusty, since it's always been inside and I've never noticed any leaks from it. There is no evidence of oil anywhere, but I did notice a good amount of metal shavings, likely from when the clutch came loose.

I can replace the clutch again with no problem, but I wonder if I need to replace the motor, or if it could be something else.

Thanks

---

The part number for 1 speed motor is wh49x10029 and for 2 speed is wh49x10035
I do not have the price on them,but you can call GE part direct line @1800 626-2002
good luck.