I have a Rudd Silhouette model UGDG-07EAUER Serial # CW5O30Z F0194 4182 - The control board appeared burned and the Gas would not come on. I replaced the control board (honeywell) S9201A with a UT Board 62-24084-82 The draft motor comes one, The ignitor glows, The gas comes on and lights... and 4-6 seconds it turns off. 20-30 seconds later the ignitor again glows, the gas comes on, ignites and again4-6 it turns off at which time the Blower motor comes on. I tried cleaning the flame sensor with steel wool and a I rechecked all connections, what am I missing

Are you sure you replace the right control board? Where did you buy ? And what info about the unit did you use?

I mean with the right /correct control board

Control board (honeywell) S9201A the replacement part is a UT Board 62-24044-91, though that was not available, I used a Master Replacement Part, UT Board 62-24084-82. This States that is replaces numerous boards, including 62-24044-91

With some of the rudd replacement boards you have to order the flame sensor kit. Its extra.