I have a Garrison RCT 100 with a wireless remote control. I have programmed my timer and the programs work correctly. I want to have the ability to override these programs at times, so I go to program (learn) the remote as per instructions. I hold the right arrow button down at the same time as the On/Off button on the command centre at the same time depressing the channel on (1) button on the remote control. It doesn't seem to work. The command centre immediately goes into the Program mode and cycles through the programs until I stop pressing the right arrow. Can anybody help. TY
[email protected]

When you see the clock displayed, press the right arrow once. You can program there the first ON time. Press SET once. You will see the days blinking. Press the left or right arrow to select the day. Press SET again; the hours will be blinking. Press the left or right arrow to select the hour, then press SET. Now the minutes will blink. Select the correct value with the left or right arrows, and press SET. The first ON time is now set. Press the right arrow once. You are now in position to program the first OFF time. Proceed as above to adjust the day, hour and minutes. When you are finished, press the right arrow once, and you are in position to program the second ON time.

You can program 20 ON and 20 OFF commands

You can find the instruction manual for the Garrison RCT100 on this page:

http://waterheatertimer.org/UPM-timers-and-manuals.html

I had the same problem. You have to have the unit plugged in to power, then you can press the learn buttons and also the remote button you want to program the timer to work with.