Ask Me Help Desk

Ask Me Help Desk (https://www.askmehelpdesk.com/forum.php)
-   Tools & Power Equipment (https://www.askmehelpdesk.com/forumdisplay.php?f=334)
-   -   Onan engine B48G stops running (https://www.askmehelpdesk.com/showthread.php?t=520638)

  • Oct 27, 2010, 02:24 AM
    malcolm35
    Onan engine B48G stops running
    L wish to know if anyone can help me with the problem with my grandsmaster toro 62inch cut mower
    It has a onan B48G engine the motor starts and then after a few minutes it dies and then after a few seconds l can start it again with out any trouble but then it dies again
    L have replaced fuel pump and points and condenser and yet it still does it
    L hope someone can help
    Cheers
    Malcolm
  • Oct 27, 2010, 09:25 PM
    amowl
    Fuel filter/ clean the lines onside the carb/remove and replace the fuel lines
  • Oct 28, 2010, 03:56 AM
    malcolm35
    L have replaced fuel filter and replaced fuel lines from tank all the way to carb
    And it continues to die after a short time of running
    Lam not sure what is next to do??
    Cheers
    Malcolm
  • Oct 28, 2010, 11:23 AM
    DG

    Check and make sure the tank venting , check fuel cap .
    If it dies again remove fuel cap and see if this helps.
  • Oct 28, 2010, 05:03 PM
    amowl
    DG has a good one.also if you can I have hooked up a bicycle pump with duct tape to the threads of the fuel fill spout and start it and give it a SLOW steady push on the pump with the motor at about 1/2 throttle
    Good 1 DG don't know how I missed that 1

  • All times are GMT -7. The time now is 10:11 PM.