My pool motor all of sudden stopped working, when I reset the circuit breaker it tryes to start but cuts out on overload, there is full voltage going to the motor, I suspect either a bad capacitor 161-193 uf @110 vac or the centrifugal switch. Do you think that I am on the right track or there is a problem with the windins? Please help.
Motor is 5KC38SN6084AX and I'ts wired for 230volts

Please send replies to [email protected]

Thank you Henry

I'd say you are on the right track.
Do you have a motor shop you can bring it to?



Sorry, I don't reply via e-mail.