Bell is the input side of SDR 35, right?

If your talking about a raised lip on the gasket then that goes on the side closest to the bottom of the lip. It's there to prevent backflow.

http://www.plastictrends.com/products/pdf/G_Series.pdf

No this stuff: http://www.lowes.com/pd_24141-1814-P...pe$identifier=

Which end is supposed to be in? It's not gasketed. Don't plan on solvent welding it to put lengths together. Drainage application.

I don't think Lowe's sells any gasketed SDR fittings.

Yes. Bell is the input side. Sorry I looked up the wrong stuff the first time. I saw the sdr35 and looked it up :)

Thanks.

Rule of thumb for all fittings with a hub.
The flow goes from the male end into the hub. Good luck, Tom

Except when it's leaving a catch basin. :D