Ask Me Help Desk

Ask Me Help Desk (https://www.askmehelpdesk.com/forum.php)
-   Electrical & Lighting (https://www.askmehelpdesk.com/forumdisplay.php?f=105)
-   -   Two questions pool pump & submersible well pump for irrigation in river (https://www.askmehelpdesk.com/showthread.php?t=480886)

  • Jun 18, 2010, 05:23 PM
    ngttom
    Two questions pool pump & submersible well pump for irrigation in river
    Have a inground pool about 5 yrs old that we replace motor every yr,the wireing & amount of juice is OK it's the sealed bearings that start squealing an freeze up, 2ND ? The well pump is 220v / 2 wire direct to breaker ,its on or off nothing fancy an has worked for years except this yr ,runs about 5 min an quits an will not come back on with breaker switch ,after about 1 or 2 hrs it runs 5 min an off again . THANK YOU FOR ANY INPUT ON MY PUMP PROBLEM Nelson Tomlinson nash Tn / [email protected]
  • Jun 19, 2010, 04:24 AM
    tkrussell
    Sorry , but your question is not easy to understand.

    Pool pump wiring and juice is OK, but the sealed bearings froze?

    Then what happened?

    The well pump was fine for years and now only runs for 5 minutes after an hour or so of cooling down.

    Not really sure what the question is.
  • Jun 19, 2010, 08:11 AM
    ngttom
    Quote:

    Originally Posted by tkrussell View Post
    Sorry , but your question is not easy to understand.

    Pool pump wiring and juice is OK, but the sealed bearings froze?

    Then what happened?

    The well pump was fine for years and now only runs for 5 minutes after an hour or so of cooling down.

    Not really sure what the question is.

    Pool pump:The volts & amps are OK for that motor,but aftera few days of motor noise the bearings lock up ,an we replace the motor again ,WHAT WOULD CAUSE THIS ABOUT EVERY YEAR?? WELL PUMP QUESTION > why would the well pump quit after 5 min of running, do they have a built in safety switch if the motor overheats ? THANK YOU
  • Jun 20, 2010, 06:02 AM
    tkrussell
    OK , that is a bit more info.

    The pool pump could be the incorrect one for that location, for the bearings to fail every year. Could be the product is just junk, if your using the same one every year.

    Bearings failing on motors every year sounds like a mechanical issue.

    Yes, well pumps have built in thermal protection that will stop the motor if the unit gets too hot.

    This could be caused by a mechanical issue, such as a closed valve, clogged pipe, or some other reason in the water line that is causing the pump to work too hard.

    Could be a voltage issue also.

  • All times are GMT -7. The time now is 09:07 PM.