Ask Me Help Desk

Ask Me Help Desk (https://www.askmehelpdesk.com/forum.php)
-   Heating & Air Conditioning (https://www.askmehelpdesk.com/forumdisplay.php?f=150)
-   -   Bryant plus 90 furnace Smells like elecrical burning. (https://www.askmehelpdesk.com/showthread.php?t=47768)

  • Dec 10, 2006, 05:34 PM
    Coryh
    Bryant plus 90 furnace Smells like elecrical burning.
    Hello,

    I hope someone can answer my question. I have a Bryant furnace Plus 90 model and I started smelling like electrical burning through one of the air ducts that goes to the upstairs of my home. It is hot right above the access panel. Could someone tell me what this could be. I can only smell this burning when the furnace is running.

    Thanks,
    Cory Haasnoot:confused:
  • Dec 10, 2006, 09:23 PM
    turnerwest
    Quote:

    Originally Posted by Coryh
    Hello,

    I hope someone can answer my question. I have a Bryant furnace Plus 90 model and I started smelling like electrical burning through one of the air ducts that goes to the upstairs of my home. It is hot right above the access panel. Could someone tell me what this could be. I can only smell this burning when the furnace is running.

    Thanks,
    Cory Haasnoot:confused:

    Cory turn the "System" switch on your thermostat to off and turn the "Fan" switch from auto to on and see if you have the "Burning" smell after about ten minutes of run time. If you do than chances are you have a fan motor getting ready to go out on you OR if no smell is present after you perform this test, it may be a "Induce drat fan motor that is starting to go bad. Eric
  • Dec 11, 2006, 11:39 AM
    Coryh
    Quote:

    Originally Posted by turnerwest
    Cory turn the "System" switch on your thermostat to off and turn the "Fan" switch from auto to on and see if you have the "Burning" smell after about ten minutes of run time. If you do than chances are you have a fan motor getting ready to go out on you OR if no smell is present after you perform this test, it may be a "Induce drat fan motor that is starting to go bad. Eric


    Thanks Eric I will give this a try.

    Cory

  • All times are GMT -7. The time now is 04:04 PM.