Ask Me Help Desk

Ask Me Help Desk (https://www.askmehelpdesk.com/forum.php)
-   Heating & Air Conditioning (https://www.askmehelpdesk.com/forumdisplay.php?f=150)
-   -   Burners won't... Follow up info (https://www.askmehelpdesk.com/showthread.php?t=47463)

  • Dec 8, 2006, 10:48 PM
    dvqjimbo1
    Burners won't... follow up info
    Burners light for couple seconds, then go out

    Weather King --- ICECO --- 80 PJ --- forced air --- Honeywell valve (on/off switch)
    Burners try to light on 1'st attempt, lights for couple seconds then out on2'nd attempt.
    Brand new furnace. Looked in installation manual -- says stuff about igniton sequence,
    Tries 4 times, soft lockout, etc.. also something about flame roll out safety switches--
    Maybe need to reset? Am kind of afraid to mess with this to much-- don't want to blow up.
  • Dec 8, 2006, 10:54 PM
    sonuvyas
    Quote:

    Originally Posted by dvqjimbo1
    Weather King --- ICECO --- 80 PJ --- forced air --- Honeywell valve (on/off switch)
    burners try to light on 1'st attempt, lights for couple seconds then out on2'nd attempt.
    brand new furnace. looked in installation manual -- says stuff about igniton sequence,
    tries 4 times, soft lockout, etc..
    need this info?

    YES
  • Dec 8, 2006, 11:13 PM
    labman
    Go over what the manual says about the flame roll out switch very carefully. If the control doesn't get the signal from the roll out switch that it has flame very soon after turning the gas on, it will turn it back off and try again a few times. If after about 3 times, and no flame signal, it quits for a while, lockout. My guess is that with a new furnace, the rollout switch is missing, misplaced, or not connected properly. Figure out the problem, and the furnace should run.
  • Dec 9, 2006, 09:14 AM
    NorthernHeat
    If this is a new install and burners light but don't stay lit I would make sure the furnace is properly grounded and that the high voltage is correct polarity, 120 volts to black and neutral is white.

  • All times are GMT -7. The time now is 07:12 AM.