I want to replace a pull switch light in a closet with a track light from IKEA. How do I control this track light without a switch? Right now, pulling the cord switches the light on/off. I'm a novice at electrical work and the only electrical work I've done is swapping out light fixtures. I don't think I will be able to add switches etc. Any suggestions? Thanks!

Remote control switch.

Any fixture with a bare incandescent lamp is not allowed in a closet.

Building codes prohibit an incandescent light in a closet.
Our building inspector will allow a light ONLY if directly over the door. (But how does one get it there after the drywall is finished?)
(The concern is that anywhere else, items may get stacked up to the light bulb and catch fire.)

I installed a light switch in the wall next to the closet and an outlet above inside in which I plugged a string of white LED Christmas lights. They provide nice light at only 7 watts and no heat.

There is also a doorjamb switch which inserts into the hinged side of the door.
But that requires a lot of effort - removal of the door and jamb - to install it.
I am seeking a magnetic switch. When the magnet on the door moves away from the switch, the circuit closes and lights turn on.

Robert, it is not the building codes, it is the National Electric Code that does not allow bare incandescent lamps in closets.

And it does not prohibit incandescent lamps entirely, I said "bare" lamps.

Track lights usually are bare lamps

You may use an incandescent lamps in a fixture that has a globe.

Using portable string lights as a permanent light source is not a good idea either.

One assumes that this is a clothes closet, correct TK?

Without specific details, yes I assume a clothes closet.

Thanks, TK.
Our inspector will not even allow a light bulb enclosed in glass and metal protected fixture - unless over the opening. To get it there, he says I should remove the drywall and patch it. I hate to do that because it will never look good.

What is the objection to the indoor/outdoor LED lights?
(Other than their being temporary?)

Also I want to put lights in under kitchen sink and under counter cabinets for a senior with diminished sight.

The magnet switches are only 1/2 amp = 60 Watts at 120 VAC.

Am considering 7-Watt LED indoor/outdoor LED strings for that, too.

Local codes can modify the National Code. My advice is often to check local codes. But as you state, your local inspector will allow an incandescent lamp in an enclosed fixture.


Temporary lights are only allowed to be used 90 days, as per the National Electric Code.

Consider that someone installs a string of lights in a closet, somehow they hang on nails, staple them etc. These cords are not built for longevity. The cords can be easily damaged, wear out, get hard brittle, crack, etc.


Ask your inspector about using Christmas lights in closets as a permanent light source.