I was replacing my transformer/fan control center for a Rheem Furnace (central Heat/air) and did not label the wires. I am now very confused... I have two sets of contact wires coming out of the relay, one set "no" and the other "nc". And the Primary wires on the transformer... How do I connect this to my furnace??

connect the common, x-former hot, and 120 line together. Connect the X-former neutral, (usually the blower motor neutral) and the line neutral together. NO goes to fan high (cooling speed) and the NC usually, goes to the fan limit control, then that goes to the blower low (heat speed)

Always double check the appliance has no power before working on it.

I am looking for wiring diagram for a rheem model # 32080CDA5 gas furnace