My toilet bowl overfills when flushed, but does not flush. The water drains slowly but leaves all materials in the bowl. I really don't want to go out and waste money on an auger or other parts for the toilet if it's not going to work. I know that may be impossible but if there is a difinitive answer I would highly appreciate it. AND, I do not have a little jet in the bowl or anything, it's an old toilet.

I have one that most repair plumbers miss.. Look down at the bottom of the bowl. If there is a small hole, then that is a jet that starts the syphon action. If it's clogged the water will just swirl around and slowly go down leaving solids behind. Take your finger,(UGH! ) and run it around the inside of the opening. Over the years minerals build up and cut down on the syphon (flush) action. If it is rough or you feel build up, take a table knife and put a bend in it to get around the curve in the bowl and chip and scrap it clear. Next take a coathanger and clear out the holes around the rim. They start the swirling action. And last, check the water level in the tank. It should be 1/2" below the top of the over flow tube. And speaking of the overflow tube, Make sure the small 1/8" tube from the ballcock to the white overflow tube is connected so it discharges in it and that it's flowing when the ballcock fills. This is what raises the water level in the bowl. For a good solid flush they all have to work together. Hope this helps and thank you for rating my reply.. Tom

Tom, your answer saved my toilet from a trip to the dump, and my pocket book! Thank you!

Always nice to see a plan come together. Thanks for the update. Tom