Check engine light stuck on and I don't get any codes at all I've done the paper clip but nothing comes on in the dash if you could help please

When you turn the ignition switch to ON (Position II), does the Check Engine Light (CEL) come on and then go off after 2 seconds? If not, the problem is with the ACG (ALT) (S) fuse, in the under dash fuse/relay box; ECM (perform the K-Test, below); main relay; or the ignition switch. Perform tests in that order.

The ECM has likely failed. Here's how to test it:

The K-Test: Remove the MAP Sensor connector and turn the ignition switch to ON (Position II). Using a multimeter, check for 5 volts going between the MAP Sensor connector's reference wire (+) and ground. As you look at the connector, this is the socket on the right. Really press the black test lead into a cleaned main ECM ground on the thermostat housing. If the voltage is low, it's probably indicating ECM failure. Most failed ECMs will record a fraction of a volt. To me, the K-Test is simple, elegant, and accurate.

Here's how to replace the ECM yourself:

https://www.askmehelpdesk.com/cars-t...tml#post235038

If I'm right, you just saved yourself $1,400.