New installed toilet problems
First of all I have 2 questions. Just a little over a week ago I had a American Standard Cadet 3 toilet installed by a handyman. Toilet flushes OK so that's good. Two days later I see water on the floor under the tank near the new flex water line. Checked line and it was tight. I then checked line constantly with a papertowel to see if I could fine any water leakage from around the screw nut. Found none. Then 4 days later water again. Now it's been 4 more days and I don't see any puddles on the floor. I don't think that this was cause by sweating of the tank either because it was dry. Where could it be from and why not a continues issue? Afraid someday I might walk into and see a terrible mess.
2nd problem is large bubbles and soap (I used too much that day) came up in the bowl when the washer was used. That sounds like a clog in the drain somewhere. It's like the pipes can't handle all the washer water and it backs up in the first availableway out. I do need to check clean out to see how water rushes through but that's hard to do when I'm only one person. My husband is out of town... great timing. I don't relate the water on the floor with splash out from washer soap because I only did laundry once and the water issue happened twice days apart. I am on septic with only 2 family members. I have it cleaned out every 3 years, mandatory where I live. It was done just last fall. Had someone check vent for bird nest, etc. They didn't see a problem but I'm not sure how good they looked. I would rather stay away from the expense of a plummer but if all else fails I'll make the call. Help!!