I have a 2000 honda accord and I'm getting a 1381 code w check engine light I changed timming belts,distributor,sparkplugs,wires,cap,oilchange,c ranksensor,rotor,cap, spent 770.00 for repairs light still comes on now car stalls out running terrible somebody help

When you replaced the distributor, did you use a genuine Honda distributor housing?

What engine?
DX, LX, or EX?

Honda accord SE Vetek yes honda cap rotor sub assmbly

Yes honda cap rotor accord SE Vetek

It sounds like the CYL Position Sensor is bad. I've never encountered this, however, on a genuine Honda distributor housing. You may have a defective distributor.

Did Honda replace the timing belt or did a local mechanic?

What and where is cyl sensor

And I caint afford honda mech

They diagnosed my prob and how do I know if dist is bad

The Cylinder Position Sensor is located inside the distributor--it is not serviceable. I would return your Honda distributor and get another one. Over half of all new aftermarket distributors for Hondas are bad out of the box. I've never seen a bad geneuine Honda distributor that was new, however. Other than that, I don't know what else to advise.

I only recommend using genuine Honda distributor housings. It's fine, however, to install aftermarket ICMs and coils in them.

I think you know the distributor is bad because it is throwing a very distinct Code 1381.