My garage door is a Chamberlain with board control model 41A3071. According to a chart, the remote model should be 61LM.

The 61LM model has 9 swith trinary code while the board on my door opener motor has only 8.

Who would know how to program? I've tried programming the first 8 leaving #9 dormant but it doesn't work.

Thanks.

How do I reprogram the remote control for my craftsman garage door opener

USING THE PREMIUM CONTROL CONSOLE

1. Enter
A four digit personal identification
Number (PIN) of your choice on the keypad.
Then press and hold ENTER.
2. While holding the ENTER button, press and
Hold the LIGHT button on the Premium
Control Console.


3. Continue
Holding the ENTER and LIGHT
Buttons while you press the push bar on the
Premium Control Console (all three buttons
Are held).

4.
Release buttons when the motor unit lights
Blink. It has learned the code. If light bulbs
Are not installed, two clicks will be heard.




USING THE "LEARN" BUTTON


1. Press
And release the "learn" button on motor
Unit. The learn indicator light will glow
Steadily for 30 seconds.
2. Within 30 seconds, enter a four digit personal
Identification number (PIN) of your choice on
The keypad. Then press and hold the ENTER
Button.


3. Release
The button when the motor unit lights
Blink. It has learned the code. If light bulbs are
Not installed, two clicks will be heard.